Click above to get retro games delivered to your door ever month! USING THE RELATIVE CHARACTER SIZE ( SR ) COMMAND The Relative Character Size ( SR ) command, specifies the size of labeling characters as a percentage of the distance between P1 and P2. For more information see the PCL 5 Printer Language Technical Reference Manual. The syntax for this command is as follows: SR width, height; or SI; LEGEND: Ec = [Ctrl] [P] [Esc] in DOS EDIT. EcE Resets the printer. Ec%0B Enters HP-GL/2 mode. IN; Initializes HP-GL/2 mode. SP1; Selects pen number 1, (black). Even though there is no physical pen, the SP command must be used to enable printing. IP-6956,-4388,6956,4388; Moves P1 to (-6956,- 4388), and P2 to (6956,4388). DT@; Defines the label terminator as the "@" character. SR;PA0,2700;LBRELATIVE LABEL SIZE@; Defaults the character size as a percentage of the P1/P2 rectangle, and moves the pen to (0,2700); prints "RELATIVE LABEL SIZE". IP0,0,5500,5500;PA0,2000; Moves P1 to (0,0) and P2 to (5500,5500); moves the pen to (0,2000). LBNEW P1 AND P2 CHANGE LABEL SIZE@; Prints "NEW P1 AND P2 CHANGE LABEL SIZE". PA0,1000;SR2.5,2.5; Moves to (0,1000) and sets the character size to 2.5% by 2.5% of the P1/P2 rectangle. LBNEW SR INSTRUCTION@;CP; Prints "NEW SR INSTRUCTION" and sends a CP for Carriage Return/Line Feed. LBCHANGES LABEL SIZE@; Prints "CHANGES LABEL SIZE." Ec%0A Enters PCL mode. EcE Sends a reset to end the job and eject the page. Copyright Hewlett-Packard Co. 1993 The information contained herein is subject to change without notice. Hewlett-Packard shall not be liable for incidental or consequential damages in connection with the use of this material.