Click above to get retro games delivered to your door ever month! USING ARC RELATIVE TO DRAW ARCS For more information see the PCL 5 Printer Language Technical Reference Manual. LEGEND: Ec = [Ctrl] [P] [Esc] in DOS EDIT EcE Resets the Printer. Ec%0B Enters HP-GL/2 mode. IN; Initializes HP-GL/2 mode. SP1; Selects pen number 1 (black). Even though there is no physical pen, the SP command must be used to enable printing. PA1500,1500;PD; Specifies the starting position as (1500,1500) and puts the pen down. AR0,2000,80,25; Draws an arc with a center point 0 Plotter Units (PLU) in the X direction and 2000 PLU in the Y direction from (1500,1500). Then it specifies an arc section to be 80 degrees (positive angle), with a chord angle of 25 degrees. AR2000,0,80; Draws an arc with a center point 2000 PLU in the X direction and 0 PLU in the Y direction from the current pen position. Then specifies the arc section to be 80 degrees (positive angle), with a default chord angle of 5 degrees. Ec%0A Enters PCL mode. EcE Send a reset to end the job and eject the page. Copyright Hewlett-Packard Co. 1993 The information contained herein is subject to change without notice. Hewlett-Packard shall not be liable for incidental or consequential damages in connection with the use of this material.